PORTABLE PAINT SPRAYER INSTRUCTIONS

Refillable, reusable. Extra versatile. Pressurized by free air

DIRECTIONS FOR OPERATING SPRAYERS

  1. ALWAYS DEPRESSURIZE SPRAYER BEFORE REMOVING ANY PARTS. The pressure may be let out of the sprayer one of the two following ways:
    • Tip the sprayer upside down and depress the trigger until no pressure is left. If some liquid is left in the sprayer when you attempt this procedure make sure you aim the nozzle at a place where a little bit of liquid can be expelled.
    • Remove #122 black cap from filler cap and use small probe to depress #121 valve core until all the pressure escapes.
  2. Remove the 15/16” hex filler cap once all the air has been let out of the sprayer.
  3. Fill sprayer 2/3 full (32 ounce maximum liquid capacity) with light, clean liquid. Make sure the liquid you are putting into the sprayer is CLEAN and FREE OF FOREIGN PARTICLES. See ACCESSORIES on page 4 for liquid filling/measuring device. NOTE: ALWAYS CHECK WITH YOUR CHEMICAL SUPPLIER IF YOU ARE NOT SURE OF COMPATIBILITY. READ CAUTION LABEL ON SPRAYER BEFORE FILLING.
  4. Replace 15/16” hex filler cap and tighten.
  5. Charge sprayer with compressed air by holding standard air chuck on valve stem of the filler cap. Hold the air chuck on the filler cap until you hear the line pressure equalize with the sprayer. Working pressure is 80-150 psi. At least 80 psi is needed to spray the full 32 oz. without a recharge of air. THE MAXIMUM PRESSURE SHOULD NOT EXCEED 200 PSI.
  6. The Model “A” sprayer is now ready to use.
  7. For best results, the liquid to be sprayed should be lighter than a No. 10 motor oil. (If liquid is too heavy a pin stream will result). DILUTE WITH A SUITABLE DILUENT UNTIL DESIRED SPRAY IS OBTAINED.

CAUTION: Never point the nozzle of sprayer toward yourself or another person. Always point the nozzle of the sprayer away from yourself and toward your intended target before depressing the trigger.

PLEASE NOTE: NOZZLE IN THE OPERATING POSITION IS SET FOR REGULAR MIST. FOR PIN STREAM, REMOVE THE #303 SPIRAL WITH NEEDLE NOSE PLIERS.

THE #118 FILLER CAP NOW COMES WITH A SPECIAL CHEMICAL RESISTANT VALVE CORE AND USES A REGULAR RIGHT HAND THREAD.

ALWAYS DEPRESSURIZE THE SPRAYER BEFORE REMOVING ANY PARTS
MAXIMUM PRESSURE 200 PSI

THIS SPRAYER IS FOR USE WITH THURMALOX STOVE PAINT AND FOR ALVIN HIGH TEMP AUTO SPRAY PAINT